Kingston 4GB 240-Pin DDR3 SDRAM ECC Registered DDR3 1066 Server Memory

KVR1066D3D8R7S/4G
4GB 512M x 72-Bit PC3-8500
CL7 Registered w/Parity 240-Pin ECC DIMM
Kingston.com Document No. VALUERAM0757-001.A00 01/09/09 Page 1
DESCRIPTION
This document describes ValueRAM’s 512M x 72-bit (4GB)
DDR3-1066 CL7 SDRAM (Synchronous DRAM) registered
w/parity, dual-rank ECC memory module, based on eighteen
256M x 8-bit DDR3-1066 FBGA components. The SPD is
programmed to JEDEC standard latency 1066Mhz timing of
7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers and
requires +1.5V. The electrical and mechanical specifications
are as follows:
FEATURES
• JEDEC standard 1.5V ± 0.075V Power Supply
• VDDQ = 1.5V ± 0.075V
• 533MHz fCK for 1066Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 6,7,8,9,10
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 6(DDR3-1066)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does
not allow seamless read or write [either on the fly using A12
or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE ? 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: